Browse Our Product Line

9700/9700i

9700/9700i

  • Designed for use in non-freezing season (May-October)
  • Portable units which easily and securely connect to fire hydrants
  • Ideal for moving to different locations within the distribution system
  • Water flushes through bottom of enclosure to grade
  • Time based automatic flusher (Model 9700)
  • Residual based automatic flusher (Model 9700i)
  • Allows for 12 flushing cycles per day
  • Flow rate capabilities: 2” Model = 150gpm, 1” Model = 40 gpm
  • De-chlorination option available  


Request More Information

9800

9800

  • Designed for use in all climates and seasons (January-December)
  • Ideal for permanent installation in targeted areas of poor water quality
  • Water is flushed within enclosure directly to sanitary sewer or storm sewer
  • Units are fully serviceable from above the ground
  • Includes integrated brass sampling point
  • Time based automatic flusher (Model  9800)
  • Residual based automatic flusher (Model 9800i)
  • Allows for 12 flushing cycles per day
  • Flow rate capabilities: 2” Model = 150gpm, 1” Model = 40 gpm
  • De-chlorination options available


Request More Information

Genesis

Genesis

Have many of the same features and functionality of the “Intelligent” flusher with the added benefit that the Genesis unit is self-powered. The Genesis flusher incorporates a water turbine and a 24VDC battery bank (no outside power source needed). The unit uses any flushed water to run the turbine which charges the batteries that provide power to the analytical equipment. Additional sensors can be incorporated including, but not limited to: temperature, pH, psi, turbidity, conductivity and ORP. Sampling lines are heated using self-regulating heat trace. Unit is fully maintainable from above ground.


Request More Information

Intelligent

Intelligent

Incorporate a built-in chlorine analyzer to measure and record disinfectant residual levels based on a programmed sampling schedule. Users can input minimum and desired residual levels, initial blow-off time and a maximum flushing duration. The unit will operate under these parameters and will flush when detected residuals are below minimum prescribed levels flushing only the exact amount of water needed until desired residuals are reached. All residual and flushing data is recorded and can be exported via micro-SD card or SCADA protocol.  This flusher requires 120 VAC line power.


Request More Information